Resources
Valve technical guides
Plain-language answers to the questions that come up when specifying and buying valves for oil and gas, pipeline and industrial service.
DBB vs DIB valves: what is the difference?
Both a double block and bleed (DBB) valve and a double isolation and bleed (DIB) valve give you two seats in one body and a bleed port to check the cavity between them. The difference is how the seats behave when pressure builds in that cavity: DBB seats (single piston effect) self-relieve to the line, while DIB seats (double piston effect) are pushed tighter against the ball and keep the cavity isolated.
Read the guide →API 6D vs API 600: what is the difference?
API 6D covers pipeline valves: ball, gate, plug and check valves for pipeline transportation systems, with requirements for pig passage, cavity relief, block-and-bleed and buried service. API 600 covers one product, bolted-bonnet steel gate valves for refinery, petrochemical and general process piping. Choose by service and by your piping specification. The two are not interchangeable.
Read the guide →API 6D vs API 6A: what is the difference?
API 6D is the standard for pipeline valves, rated by ASME pressure class. API 6A is the standard for wellhead and Christmas tree equipment, rated by working pressure from 2,000 to 20,000 psi and specified by product specification level (PSL), performance requirements, and material and temperature classes. A valve built to API 6D is not an API 6A valve, and the reverse is also true.
Read the guide →What is a valve figure number, and how do you read one?
A valve figure number is a manufacturer's code that describes one specific valve: its type, size, end connection, pressure class, body material, trim, operator and service, in a single string. The format belongs to each manufacturer. There is no industry-wide standard, so the same code means different things at different manufacturers. Read it field by field against that manufacturer's ordering guide.
Read the guide →How do you check the quality of cast steel valve castings?
Check four things: the material test reports match the specification, every heat is traceable to the part, the casting is inspected for surface and internal defects, and each finished valve is pressure tested after final machining. A water hydrotest alone can miss pinhole defects, so ask what else the supplier does, such as a submerged gas shell test.
Read the guide →